Pull-Type Jacks

Hamilton Form’s Pull-type Tensioning Jacks are commonly used for single stroke tensioning on long-line forms where handling equipment is available and there is ample room at the end of the bed.

Tensioning jacks are available in 36″, 48″ and 60″ strokes for 1/2″ or .6 strand. A “Y”-chain sling is included for easy manipulation into strand, a magnetic torpedo level is included to make sure the unit is level and an anti-twist bar on the pulling yoke can be used to measure elongation.

PS-3500 FOR 1/2″ STRAND SPECIFICATIONS:

  • MODEL: PS35K/36/JACK
  • capacity: 35,100 pounds
  • Tensioning Stroke: 36 inches
  • Ram Pull Area: 10 square inches
  • Nose Length: 9 inches
  • Overall Length: 105 inches
  • Weight: 250 pounds
  • MODEL: PS35K/48/JACK
  • Capacity: 35,100 pounds
  • Tensioning Stroke: 48 inches
  • Ram Pull Area: 10 square inches
  • Nose Length: 9 inches
  • Overall Length: 129 inches
  • Weight: 290 pounds
  • MODEL: PS35K/60/JACK
  • Capacity: 35,100 pounds
  • Tensioning Stroke: 60 inches
  • Ram Pull Area: 10 square inches
  • Nose Length: 9 inches
  • Overall Length: 153 inches
  • Weight: 328 pounds

PS-4600 FOR 0.6 STRAND SPECIFICATIONS:

  • MODEL: PS46K/48/JACK
  • Capacity: 47,000
  • Tensioning Stroke: 48 inches
  • Ram Pull Area: 16.49 square inches
  • Nose Length: 9 inches
  • Overall Length: 130 inches
  • Weight: 425 pounds
  • MODEL: PS46K/60/JACK
  • Capacity: 47,000
  • Tensioning Stroke: 6048 inches
  • Ram Pull Area: 16.49 square inches
  • Nose Length: 9 inches
  • Overall Length: 530 inches
  • Weight: 460 pounds